151
Initial Setting Level Section 7-5
Communications
Settings
See Also
3-10 Starting and Stopping Control (page 38)
7-5-16 Transfer Output Upper Limit (tr1h)/(tr2h)/(tr3h)/(tr4h)
Transfer Output Lower Limit (tr1l)/(tr2l)/(tr3l)/(tr4l)
Condition: The transfer output must be allocated in the control outputs
or auxiliary outputs for an analog output model.
Function • This parameter sets the transfer output upper and lower limits used for
scaling when transfer output is allocated for control and auxiliary output.
• When SP transfer output, ramp SP transfer output, or PV transfer output
are allocated, the following parameters can be changed to force the trans-
fer output upper and lower limits to change to the limits determined for
each parameter.
Input type, scaling upper limit, scaling lower limit, SP upper limit,
SP lower limit, temperature unit, and decimal point
• When cooling control output is not allocated for output, and cooling MV
transfer output is allocated, the output will always be 0%.
• When transfer output is not allocated, the settings can still be changed
and read.
Communications
ch Variable type Address
Shared C3 0012 or 0112
Setting range Unit Default
00000000H to 00000001H
0: Stop (no)
1: Continue (yes)
-0: Stop
Parameter Display ch Variable type Address
OUT1 transfer out-
put upper limit
tr1h Shared C3 0031 or 0131
OUT1 transfer out-
put lower limit
tr1l Shared C3 0032 or 0132
OUT2 transfer out-
put upper limit
tr2h Shared C3 0033 or 0133
OUT2 transfer out-
put lower limit
tr2l Shared C3 0034 or 0134
SUB3 transfer out-
put upper limit
tr3h Shared C3 0035 or 0135
SUB3 transfer out-
put lower limit
tr3l Shared C3 0036 or 0136
SUB4 transfer out-
put upper limit
tr4h Shared C3 0037 or 0137
SUB4 transfer out-
put lower limit
tr4l Shared C3 0038 or 0138
To Next Page
Loading...
