Trajexia Tools interface
PROGRAMMING MANUAL 199
Revision 3.0
Controller configuration
fig. 26
Shows the hardware configuration screen of the controller
hardware that is connected to the PC.
Controller: The PC is connected to a Trajexia Motion Controller
(TJ1-MC__) with 1.64 Dev. 94 software The servo period is
1000μs.
Axis: Shows the axes that are available.
Comms: The communication capability of the Trajexia Motion
Controller.
I/O: The type and range of the digital, analog and virtual inputs and
outputs.
CANIO
Not implemented for Trajexia.
I52E-EN-03.book Seite 199 Freitag, 29. Juni 2007 11:55 11
To Next Page
Loading...
Need help?
General
