Omron V430-F Series User Manual

6-40 Auto Focus Multi Code Reader V430-series User’s Manual (Z392)
DotCode
DotCode
Important: When DotCode is enabled, no other symbologies will be decodable. You must
disable DotCode to decode symbols of any other type.
DotCode Status
Disabled
The reader will not attempt to decode DotCode symbols.
Enabled
The reader will attempt to decode DotCode symbols.
Rotation Mode
No Rotation
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
Low Rotation
The reader will decode +/– approximately 10 degrees from the horizontal or vertical
symbols. It is slightly slower than the No Rotation option.
OmniDirectional
The reader will support 360 degree reading. Omnidirectional is significantly slower than
the other two options.
Serial Cmd: <K497,status,rotation mode>
Default: 0 = Disabled
Options: 0 = Disabled
1 = Enabled
Serial Cmd: <K497,status,rotation mode>
Default: 0 = No Rotation
Options: 0 = No Rotation
1 = Low Rotation
2 = Omnidirectional

Omron V430-F Series Specifications

General

Brand	Omron
Model	V430-F Series
Category	Barcode Reader
Language	English