Auto Focus Multi Code Reader V430-series User’s Manual (Z392) 13-19
Utilities
Default/Reset/Save
Understanding and controlling your reader’s active, saved, and default settings is critical to
its successful operation.
Resets
Resets (“A” commands) affect only the current settings (active memory) and are not saved
for power-on.
Saved for Power-on
Power-on parameters (“Z” commands) are saved to NOVRAM and recalled and loaded
into current parameters when power is cycled to the reader or the <Arp> command is
issued.
Defaults
Defaults are Microscan firmware settings or saved customer settings that can be recalled,
either by software or hardware reset.
Function
Serial
Cmd
ESP (first, right-click in any
menu tree)
a
a. When you right-click in a menu tree and select Default Current Menu Settings or Default All ESP
Settings, it is important to note that only ESP settings are defaulted. To save these defaults to the
reader itself, you need to follow up with a Save to Reader, Send and Save command.
Resets
(not saved
for power-on)
Reset <A>
Save to Reader,
Send No Save
Reset and Recall Microscan Defaults <Ard>No
Reset and Recall Power-On Parameters
<Arp>No
Reset and Recall Customer Default
Parameters
<Arc>No
Saved for Power-on
Save Current Settings for Power-On <Z>
Save to Reader,
Send and Save
Save Current Settings as Customer
Default Parameters for Power-On
<Zc>
Save to Reader,
Send and Save Customer
Defaults for Power-On
b
b. Only available in ESP if enabled under the Options dropdown menu.
Recall Microscan Default Parameters
and
Save for Power-On
<Zrd>No
Recall Customer Default Parameters and
Save for Power-On
<Zrc>No
To Next Page
Loading...
Need help?
General
