Auto Focus Multi Code Reader V430-series User’s Manual (Z392) 7-61
I/O Parameters
Database Identifier Output
Output Status
Disabled
When this command is disabled, no database identifier information will be output.
Enabled
When this command is enabled, the reader will append a two-digit number and the characters
“DB” to the data output following the separator for each symbol decoded using
Configuration
Database
. For example, if the separator is an underscore character and the second database
entry reads a symbol encoded with “data capture” during the read cycle, the symbol data
output will be “data capture_DB02”. If the database is not active, no identifiers will be
attached to output.
Separator
Usage: Useful in keeping track of which database entries read which symbols.
Serial Cmd: <K759,status,separator>
Default: 0
Options: 0 = Disabled 1 = Enabled
Usage:
The separator character separates the symbol data from the database identifier.
Serial Cmd: <K759,status,separator>
Default: <space>
Options: Any ASCII character.
To Next Page
Loading...
