Auto Focus Multi Code Reader V430-series User’s Manual (Z392) 3-13
Communications
Response Timeout
Usage: Only used when a response is required from the host. The reader can be
set to wait indefinitely by setting Response Timeout to zero.
Definition: The time that the reader will wait before timing out if ACK, NAK, and ETX
are enabled, and a host response is expected.
Serial Cmd: <K143,response timeout>
Default: 12 (in 1 ms increments)
Options: 0 to 255 (A zero (0) setting causes an indefinite wait.)
To Next Page
Loading...
