7-18 Auto Focus Multi Code Reader V430-series User’s Manual (Z392)
Setup Button
Default on Power-On
Load Configuration Database
Save for Power-On
Definition: When enabled, if the Setup button is held down on power-on the imager
will default to customer defaults and save for power-on. This is the same
as sending a <Zrc> command.
Serial Cmd: <K770,global status,default on power-on,load Configuration Database,
save for power-on>
Default: Enabled
Options: 0 = Disabled 1 = Enabled
Definition: Allows the user to load the Configuration Database with calibration results.
When the user performs a calibration using the Setup button, all the data-
base entries are moved down one index and the results of the calibration
are saved to index 1. The results will be saved as current settings as well.
Serial Cmd: <K770,global status,default on power-on,load Configuration Database,
save for power-on>
Default: Enabled
Options: 0 = Disabled 1 = Enabled
Definition: If enabled, after calibration is complete, all parameters will be saved for
power-on.
Serial Cmd: <K770,global status,default on power-on,load Configuration Database,
save for power-on>
Default: Disabled
Options: 0 = Disabled 1 = Enabled
To Next Page
Loading...
Need help?
General
