Omron V430-F Series - Page 332

Auto Focus Multi Code Reader V430-series User’s Manual (Z392) 13-1
13 Utilities
Contents
Utility commands are generally commands that are performed during reader operations to
check or determine read rates, or to perform miscellaneous operations on reader hardware.
Serial utility commands are not prefaced with a “
K ” and a numeric code, nor do they require an
initialization command (
<A> and <Z> ). They can be entered from within any terminal program
or from
ESP ’s Terminal or Utilities windows.
Operational Commands.............................................................................................................. 13-2
Read Rate .................................................................................................................................. 13-4
Counters..................................................................................................................................... 13-6
Device Control............................................................................................................................ 13-8
Differences from Default............................................................................................................. 13-9
Master Database ...................................................................................................................... 13-10
Firmware................................................................................................................................... 13-16
Default/Reset/Save................................................................................................................... 13-19
Reader Status Requests .......................................................................................................... 13-21
Other Operational Serial Commands ....................................................................................... 13-23