Panasonic AV-HS6000 - Page 84

– 84 –
Chapter 5 Basic Operations — Memory
[Lead] Moves to the rst event point.
[<Step] Moves to the previous event point.
[>Step] Moves to the next event point.
[Last] Moves to the last event point.
4
Set [Play], [Pause], and [Reverse] in the [Control2] column.
[Play] Plays back an event memory.
[Pause] Stops the event memory.
[Reverse] Reverses the playback direction (event numbers are put in their reverse sequence).
5
Select an item in [Fader Link] in the [Control2] column.
f Playback of event memories can be linked with the fader lever operation. In that case, BKGD and key transitions are not performed.
[Off] Does not play back an event memory according to the fader lever operation.
[ME1] Plays back an event memory according to the operation of the [ME1] fader lever.
[ME2] Plays back an event memory according to the operation of the [ME2] fader lever.
6
Select an item in [Fader Mode] in the [Control2] column.
f Set the mode for fader link.
[Total Event] Assigns 0% to 100% of the fader lever operation to the total time of the event memory.
[Event Paddle] Assigns 0% to 100% of the fader lever operation to one event in the event memory.
Using the unit, set the images or operations to be kept in the memory.
7
Select an item in the [Edit1] column.
f Add or modify events.
[New] Initializes the work memory.
[Insert]
Inserts events.
If the edit point is an event point, the event is inserted after the event point.
If the edit point is at any midway position in an event, the event is inserted at the edit point.
[Delete] Deletes events.
[Modify]
Modies events.
This key cannot be operated if the edit point is not over the event point.
8
Select an item in [(Modify Target)] in the [Edit1] column.
f Specify the range to modify the [Path] column setting at [Modify].
[off] Does not specify multiple events.
[pre] Modies the events positioned earlier in timeline than the current edit point.
[after] Modies the events positioned later in the timeline than the current edit point.
[all] Modies all events.
9
Select an item in the [Edit2] column.
f Add or modify events.
[Copy]
Copies an event.
The event is not copied if the edit point is not over the event.
[Paste]
Pastes the copied event.
If the edit point is an event point, the copied event is inserted after the event point.
If the edit point is at any midway position in an event, the event is inserted at the edit point.
[Undo]
Undoes the editing operation of the event.
When the button is pressed, the operation performed last is canceled.
10
Repeat steps 3 to 9 to edit a series of operations.
11
When the editing is complete, set [Edit] in the [Control1] column to [Off].
f The edit mode ends. During editing, playback operation is not possible including the other panels.
f After registration, always save the register memory.
Playing back the work memory to check
Play back the timeline in the work memory newly registered or edited to check.
@@
NOTE
t During editing by setting an item to [On] using [Edit] in the [Control1] column, playback operations including other panels are not possible. When the
item is set to [Off] and played back using the [Play] tab, playback operations can also be performed with other panels.
t The target cannot be played back if the following playback operations are performed using another operation area.
- When the same resource is being played back at the shot memory or event memory
1
Select the <MEM> button → [EVENT MEMORY] → [Play] tab.