Panasonic EBL512 - Page 117

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
115
""
Sensor: 00000N
Current algorithm: nnnnnn
""
Sensor: 00000N Min: XX°C
Momentary: XX°C Max: XX°C
""
Sensor: 00000N
Current algorithm: nnnnnn
"Return"
Start Sensor : 000000
Write the sensor's techn.
number and/or press "A"
to accept or press
"Return" to menu U5.
"Return"
Sensor values
Printout: (1=yes) U5
Scroll or press "Return"
to menu H4. Scroll or
press "Return" to log off.
When scrolling the message "Please Wait….." might be shown for "a second" and "No more sensors
found in the system" (before the lowest and after the highest possible technical number in the system).
Here follows the alternative "1" (printout).
Scroll to menu U5.
Sensor values
Printout: (1=yes) U5
Press "1" to accept.
"1"
Start Sensor : 000000
End Sensor :
Write the techn. numbers
and/or press "A" to
accept.
"A"
Printing started. To stop printing press
C and 0 simultaneously ACCEPT?
Press "A" and menu U5
will be shown again.
"A"
Start Sensor : 000000
Write the sensor's techn.
number and/or press "A"
to accept or press
"Return" to menu U5.
"Return"
Sensor values
Printout: (1=yes) U5
Scroll or press "Return"
to menu H4. Scroll or
press "Return" to log off.
Perf. Factor = Performance factor:
Low (min. 0) = The detector is mounted in a "stable" environment.
High (max. 2.55) = The detector is mounted in an "unstable" environment.
See also Planning Instructions, chapter "Performance factor".
Table showing the algorithms and the shortenings respectively: