Panasonic EBL512 - Access Level 3

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
26
7.4 Access level 3
From access level 2
27
, the user can logon to access level 3, which
gives access to the following menus, normally used by service
personnel:
Same menus as in access level 2 plus the following:
H8 Maintenance
S1 Disable or re-enable outputs for routing equipment (Fire
brigade tx & Fault tx)
S2 Disconnect loop.
S3 Re-connect loop.
S4 Acknowledge service signal.
S5 Clear weekly average.
S6 De-activate alert annunciation function.
S7 Test alarm devices.
S8 Safe shut down of control unit.
S9 Activate address in alarm mode.
S10 Synchronize the control units.
S11 Change access code for maintenance (access level 3).
27
If code for access level 3 or 4 has been used to logon to access level 2,
new logon to access level 3 is not required.