Panasonic EBL512 - Sensors Activating SERVICE Signal (H4;U6)

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
122
27.6 Sensors activating SERVICE signal (H4/U6)
Service signal is indicated by LED "Service" (L12). The sensor week
average value is below or over the service level respectively for one or
more sensors. (Regarding the service signal levels, see Planning
Instructions, chapter "Service signal".
Menu H4/U6 is a list of the sensor(s) activating service signal.
NOTE! Service signal is only information that the sensors have to be
cleaned / replaced soon. The service signal has to be acknowledged,
see chapter "Acknowledge SERVICE signal (H8/S4)", page 145.
It is not possible to get a print-out from menu H4/U6.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 92.
Scroll to menu H4.
Present system status on display and
printer ACCEPT? H4
"A"
Disablement
Printout: (1=yes) U1
Scroll to menu U6.
Sensors activating SERVICE signal
U6
Press "A" to accept.
"A"
Sensor : xxxxxx needs service
L
L = a list in which you
can scroll. Press "Return"
to menu U6. (If there are
no sensors in the list,
menu U6 will be shown
again.).
"Return"
Sensors activating SERVICE signal
U6
Scroll or press "Return"
to menu H4. Scroll or
press "Return" to log off.