Panasonic EBL512 - Change access code for service (H5;A11)

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
135
28.10 Activate address setting mode for DU
(H5/A9)
This function can be used by commissioning / service engineer to
activate the address setting mode in the following Display Units
connected to an Ext. FBP / DU interface board 1587 in the c.i.e.:
 Ext. Presentation unit 1728
 Alert Annunciation unit 1735 / 1736
 Ext. FBP 1826 / 1828
A specific unit or all units connected to one 1587 board can be
activated for address setting.
NOTE! The units have to be in operation and in quiescent condition,
i.e. the units have to have an address already.
Action
Text in display
Comments
"Access"
According to chapter
"Access code for service
(H5)", see page 126.
Scroll to menu A9
Activate address setting mode for DU
ACCEPT? A9
"A"
Activate address setting mode for DU
CU 00, 1587-board 0, DU 00 ACCEPT?
Write control unit number,
the board number (0-1)
and the unit's address (99 =
All units on the selected
1587-board). Press "A" to
accept.
"A"
Activate address setting mode for DU
ACCEPT? A9
Scroll or press "Return" to
H5. Scroll or press
"Return" to log off.
The address is thereafter edited in the unit respectively.