Panasonic EBL512 - Disconnect loop (H8;S2)

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
141
31 Maintenance (H8)
31.1 Access code for maintenance
Access code for access level 3 is required for menu H8.
NOTE! If login to level 2 was made with code for level 3 or 4, no
code to access level 3 is required here.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 92.
Scroll to menu H8.
Maintenance
ACCEPT? H8
"A"
Access code: _
When required (see
above), enter the access
code for level 3.
Enter the code (4 digits)
Access code: 
The digits are replaced
() in the display.
NO ACCESS!
The access code was not
correct. Try again.
Disable or re-enable outputs for
routing equipment ACCEPT? S1
The access code was
correct. This is menu S1.
Press "A" to accept or
scroll to the following
menus (S2-S8).