Panasonic EBL512 - Change Access Code for Maintenance (H8;S11)

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
154
31.12 Change access code for maintenance
(H8/S11)
For security reasons, the default code should be changed.
Action
Text in display
Comments
"Access"
According to chapter
"Access code for
maintenance", see page
141.
Scroll to menu S9.
Change access code for maintenance
ACCEPT? S11
"A"
Access code: _
New code: Verify:
Enter the old code, the
new code and the new
code again.
Access code: ****
New code: **** Verify: ****
The digits are replaced
(****) in the display.
Incorrect access code, NO change
The code was not correct.
Try again.
Change access code for maintenance
ACCEPT? S11
The code was correct and
is now changed to the new
code. Scroll or press
"Return" to menu H8.
Scroll or press "Return" to
log off.
NOTE! After change of access code it is recommended do a "Safe
shutdown of the control unit" (see menu H8/S8). This will save the
SSW data (e.g. the new code) in a Flash ROM (see page 88).
If the valid access code is unknown a "back door code" is available.