Panasonic EBL512 - Acknowledge FAULTS (H6)

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
136
28.11 Change access code for PC-
communication (H5/A10)
As a protection against unauthorised personnel programming the
system (via Win512), an access code (level 5) for PC-connection is
required. For security reasons, the default code should be changed.
NOTE! This code requires eight (8) digits.
Action
Text in display
Comments
"Access"
According to chapter
"Access code for service
(H5)", see page 126.
Scroll to menu A10
Change access code for PC-communication
ACCEPT? A10
"A"
Access code: _
New code: ******** Verify: ********
The digits are replaced
(********) in the display.
Incorrect access code, NO change
The code was not correct.
Try again.
Change access code for PC-communication
ACCEPT? A10
The code was correct and
is now changed to the new
code. Scroll or press
"Return" to H5. Scroll or
press "Return" to log off.
NOTE! After change of access code it is recommended do a "Safe
shutdown of the control unit" (see menu H8/S8). This will save the
SSW data (e.g. the new code) in a Flash ROM (see page 88).