Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
37
Regarding DIL-Switch address setting on some old units, see dwg
512-71.
Regarding the address 000: Address 000 cannot be set with the
Address setting tool 3314, i.e. only addresses 001 – 127 can be used.
A brand new detector has the address 000 factory set. Connected on
the COM loop, the LED will start blinking every second as
information that an address has to be set before the detector will work.
To Next Page
Loading...
