Panasonic EBL512 - Page 7

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
5
29 Acknowledge FAULTS (H6) ________________ 138
30 Perform ZONE TEST (test mode) (H7) _______ 139
31 Maintenance (H8) _________________________ 141
31.1 Access code for maintenance _______________________ 141
31.2 Disable or re-enable outputs for routing equipment (H8/S1) 142
31.3 Disconnect loop (H8/S2) ___________________________ 143
31.4 Re-connect loop (H8/S3) ___________________________ 144
31.5 Acknowledge SERVICE signal (H8/S4) _______________ 145
31.6 Clear weekly average (H8/S5) ______________________ 146
31.7 De-activate alert annunciation function (H8/S6)_________ 147
31.8 Test alarm devices (H8/S7) _________________________ 148
31.9 Safe shut down of control unit (H8/S8) _______________ 149
31.10 Activate address in alarm mode (H8/S9) ____________ 150
31.11 Synchronize the control units (H8/S10) _____________ 152
31.12 Change access code for maintenance (H8/S11) _______ 154
32 Interlocking outputs and inputs (H9) _________ 155
32.1 Activated interlocking outputs/inputs (H9/C1) __________ 155
32.2 Activate interlocking output (H9/C2) _________________ 156
32.3 Reset interlocking output (H9/C3) ___________________ 157
32.4 Disable interlocking output (H9/C4) __________________ 158
32.5 Re-enable interlocking output (H9/C5) ________________ 159
33 Change access code for daily duties (H10) _____ 160
34 Annual control ___________________________ 161
35 How to change paper in the printer __________ 162
36 Replacing a TLON connection board and/or a main
board 163
37 Battery maintenance _______________________ 164
38 How to avoid unnecessary (nuisance) fire alarms 165
39 Information regarding radioactive radiation source167
40 Revision history ___________________________ 168