Panasonic FP0 - FP0 Wiring; 7.1 Safety Instructions; 7.2 Wiring the Power Supply to the Control Unit; 7.3 Grounding

To Next Page

To Previous Page

Chapter 7

Wiring

7.1 Safety Instructions 7 − 3..............................

7.1.1 Interlock Circuit 7 − 3.........................

7.1.2 Emergency Stop Circuit 7 − 3..................

7.1.3 Start Up Sequence 7 − 3......................

7.1.4 Momentary Power Failures 7 − 4...............

7.1.5 Protecting Power Supply and Output

Sections 7 − 4................................

7.2 Wiring the Power Supply to the Control Unit 7 − 5........

7.3 Grounding 7 − 7......................................

7.4 Input Wiring 7 − 9....................................

7.4.1 Sensors 7 − 9................................

7.4.2 LED-Equipped Reed Switch 7 − 10............

7.4.3 Two-Wire Type Sensor 7 − 10.................

7.4.4 LED-Equipped Limit Switch 7 − 11..............

7.5 Output Wiring 7 − 12.................................

7.5.1 Protective Circuit for Inductive Loads 7 − 12.....

7.5.2 Precautions for Using Capacitive Loads 7 − 13..

7.6 Wiring the Terminal Type 7 − 14.......................

7.7 Wiring the MOLEX Connector Type 7 − 16..............

7.8 Wiring the MIL Connector Type 7 − 18.................

7.8.1 Contact Puller Pin for Rewiring 7 − 19..........

7.9 Wiring the RS232C Port 7 − 20........................

Related product manuals