Panasonic FP0 - Chapter 11 Self-Diagnostic and Troubleshooting; Allowing Duplicated Output; Continuing after an Operation Error

Self-Diagnostic and Troubleshooting FP0
11 − 4
11.1 Self-Diagnostic Function
11.1.1 Allowing Duplicated Output
When you change system register 20 settings (“ENAB”) using the programming
software, duplicated output is not regarded as an error and the FP0 continues to
operate.
11.1.2 Continuing After an Operation Error
When you change system register 26 settings (“CONT”) using the programming
software, the FP0 continues to operate. In this case, even if the FP0 continues to
operate, this is regarded as an error.