Panasonic FP0 - Page 370

14-128
Error
code
Name
Opera-
tion
status
Description and steps to take
FP0 FP-e FPΣ FP-X FP1/FP-M FP2 FP2SH FP10SH FP3
E38
MEWNET-F
slave I/O
terminal
mapping
error
Stops
I/O mapping for remote I/O terminal
boards,remote I/O terminal units and
I/O link is not correct.
⇒Re-configure the I/O map for slave
stations according to the I/O points of
the slave stations.
A A A A
E39
IC card
read error
Stops
When reading in the program from the
IC memory card(due to automatic
reading because of the dip switch
setting or program switching due to
F14(PGRD) instruction):
- IC memory card is not installed.
- There is no program file or it is
damaged.
- Writing is disabled.
- There is an abnormality in the
AUTOEXEC.SPG file.
- Program size stored on the card is
larger than the capacity of the CPU.
⇒Install an IC memory card that has
the program proterly recorded and
execute the read once again.
A A
Abnormal I/O unit.
FPΣ, FP-X:
Check the contents of special data
register DT90002 and abnormal FPΣ
expansion unit (application cassette for
FP-X). Then check the unit.
FP2 and FP2SH:
Check the contents of special data
registers DT90002,DT90003 and
abnormal I/O unit.Then check the unit.
Selection of operation status using
system register21:
-to continue operation,set 1
-to stop operation,set 0
Verification is possible in FPWIN
GR/Pro at”I/O error” in the status
display function.
E40 I/O error
Sele-
ctable
MEWNET-TR communication error
FP3 and FP10SH:
Check the contents of special data
registers(FP3:DT9002,DT9003,FP10S
H:DT90002,DT90003) and the
erroneous master unit and abnormal
I/O unit. Then check the unit.
Selection of operation status using
system register21:
-to continue operation,set 1
-to stop operation,set 0
Verification is possible in FPWIN
GR/Pro at”I/O error” in the status
display function.
A A A A A A
A:Available