14-132
Error
code
Name
Opera-
tion
status
Description and steps to take
FP0
FP-e
FPΣ
FP-X
FP1/FP-M
FP2
FP2SH
FP10SH
FP3
E50
Backup
battery
errror
Conti-
nues
The voltage of the backup battery
lowered or the backup battery of conrol
unit is not installed.
⇒ Check the installation of the backup
battery and then replace battery if
necessary.
By setting the system register 4, you can
disregard this self-diagnostic error.
AAA
A
Note
)
A A A A
E51
MEWNET-F
terminal
station
error
Conti-
nues
Terminal station setting was not properly
performed.
Check stations at both ends of the
communication path,and set them in the
terminal station using the dip switches.
A A A A
E52
MEWNET-F
I/O update
synchro-
nous error
Conti-
nues
Set the INITIALIZE/TEST
selecto1inmjvbgycfrde892 r to the
INITIALIZE position while keeping the
mode selector in the RUN position.If the
same error occurs after this,please
contact your dealer.
A A A A
E53
Multi-CPU
I/O regis-
tration
error
(CPU2
only)
Conti-
nues
Abnormality was detected when the multi-
CPU system ws used.
Please contact your dealer.
A A
E54
IC memory
card back-
up battery
error
Conti-
nues
The voltage of the backup battery for the
IC memory card lowered. The BATT.LED
does not turn on.
Charge or replace the backup battry of IC
memory card.(The contents of the IC
memory card cannot be guaranteed.)
A A
E55
IC memory
card back-
up battery
error
Cont-
inues
The voltage of the backup battery for IC
memory card lowers.The BATT.LED does
not turn on.
Charge or replace the backup battery of
IC memory card.
(The contents of the IC memory card
cannot be guaranteed.)
A A
E56
Incompat-
ible IC
memory
card error
Cont-
inues
The IC memory card installed is not
compatible.
Replace the IC memory card compatible
with FP2SH/FP10SH.
A A
E57
No unit for
the
configu-
ration
Conti-
nues
MEWNET-W2
The MEWNET-W2 link unit is not
installed in the slot specified using the
configuration data.
Either install a unit in the specified slot or
change the parameter.
A A
A:Available
To Next Page
Loading...
