Panasonic FP0 - Page 9

Table of Contents
FP0
vii
3.4.11 E16YT 3 − 27.................................................
3.4.12 E16YP 3 − 28.................................................
Chapter 4 S−LINK Control Unit
4.1 Names and Functions 4 − 3.............................................
4.2 Specifications 4 − 5.....................................................
4.2.1 General Specifications 4 − 5.....................................
4.2.2 S−LINK Controller Specifications 4 − 6............................
4.3 Wiring the Power Supply 4 − 7...........................................
4.3.1 Wiring to Power Supply Connector 4 − 7...........................
4.3.2 Wiring to S−LINK Terminal Block 4 − 7............................
4.4 Sequence of Turning on Power Supplies 4 − 9.............................
4.5 Operation When Power Supply is Turned On 4 − 10........................
4.6 S−LINK System Address Recognition 4 − 11...............................
4.6.1 Recognizing the Address 4 − 11..................................
4.6.2 Address Setting of S−LINK I/O Device 4 − 12......................
4.7 Judging Errors from the Error Indicators 4 − 13............................
4.8 Judging Errors Address Displays 4 − 14..................................
Chapter 5 I/O Allocation
5.1 I/O Number 5 − 3.......................................................
5.2 Control Unit 5 − 4......................................................
5.3 Expansion I/O Unit 5 − 5................................................
Chapter 6 Installation
6.1 Adding Expansion Units 6 − 3...........................................
6.2 Important Notes 6 − 5...................................................
6.3 Attachment to DIN Rails 6 − 8............................................
6.4 Installation Using FP0 Slim Type Mounting Plate 6 − 9......................
6.5 Installation Using FP0 Flat Type Mounting Plate 6 − 10.....................
Chapter 7 Wiring
7.1 Safety Instructions 7 − 3................................................