Panasonic KX-UTG200

Value Range (-80)–0
Default Value 0
HOLD_TONE_RPT
Value Format Boolean
Description Specifies whether the hold tone is repeated.
Value Range
• Y/Yes (Repeat)
• N/No (No Repeat)
Default Value
Y
HOLD_TONE_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of the hold tone using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 500 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 500,190,190,190,2890
HOLD_ALARM_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone frequencies, in hertz, of the hold alarm using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Default Value 425
HOLD_ALARM_GAIN
Value Format Integer
Description Specifies the gain, in decibels, of the hold alarm.
Value Range (-80)–0
Default Value 0
308 Administrator Guide Document Version 2015-01
5.6.8 Tone Settings