Panasonic KX-UTG200

HOLD_ALARM_RPT
Value Format Boolean
Description Specifies whether the hold alarm is repeated.
Value Range
• Y/Yes (Repeat)
• N/No (No Repeat)
Default Value
Y
HOLD_ALARM_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of the hold alarm using up to 10
whole numbers (on 1, off 1, on 2, off 2…) separated by commas.
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 120,14880
CW_TONE1_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone frequencies, in hertz, of call waiting tone 1 using
2 whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Default Value 425
CW_TONE1_GAIN
Value Format Integer
Description Specifies the gain, in decibels, of call waiting tone 1.
Value Range (-80)–0
Default Value 0
CW_TONE1_RPT
Value Format Boolean
Description Specifies whether call waiting tone 1 is repeated.
Document Version 2015-01 Administrator Guide 309
5.6.8 Tone Settings