590 Series DC Digital Drive Programming
D-11
Legacy implementation Version 9.x and onwards implementation
Tens + Comp Calc. [478] → Diameter Calc.::Output [706] → [651] Link 36 [478] →
Preset Dest [573] → Preset Speeds::Preset O/P [572] → [654] Link 39 [573] →
Sramp Dest [590] → Sramp::Sramp Output [589] → [655] Link 40 [590] →
Enhancements to input links
Legacy implementation Version 9.x and onwards implementation
→ [097] Digout 1 (B5)::Source Tag → [097] Link 13 [629] → [683] Digital Output 1::Input
→ [098] Digout 2 (B6)::Source Tag → [098] Link 14 [630] → [684] Digital Output 2::Input
→ [099] Digout 3 (B7)::Source Tag → [099] Link 15 [631] → [685] Digital Output 3::Input
→ [134] Configure 5703::Source Tag → [134] Link 16 [1190] → [714] 5703 Out::Input
→ [251] Anout 1 (A7)::Source Tag → [251] Link 17 [632] → [678] Analog Output 1::Input
→ [252] Anout 2 (A8)::Source Tag → [252] Link 18 [633] → [679] Analog Output 2::Input
→ [306] Standstill::Source Tag → [306] Link 19 [634] → [699] Standstill::Input
→ [390] Link 11::Source Tag → [390] Link 11 [1188] → [686] Advanced 1::Input 1
→ [394] Link 11::Aux.Source → [394] Link 41 [656] → [687] Advanced 1::Input 2
→ [395] Link 12::Source Tag → [395] Link 12 [1189] → [688] Advanced 2::Input 1
→ [399] Link 12::Aux.Source → [399] Link 42 [657] → [689] Advanced 2::Input 2
Simplification of function blocks
Some function blocks from previous versions of firmware have been re-arranged to clarify the functionality of each block. The changes are:
SETPOINT SUM 1: The Deadband function has been extracted into a new DEADBAND function block.
5703: This has been split into function blocks 5703 IN and 5703 OUT to improve function block execution order.
AUX IO: This has been split into a new SEQUENCING function block and a smaller AUX I/O block.
PID: The Gain Profile function has been extracted into a new PROFILED GAIN function block.
RAMPS: The Minimum Speed function has been extracted into a new MIN SPEED function block.
In addition, the old Diameter Calc, Taper Calc and Tension & Comp blocks have been combined into a single block called Diameter Calc due to the
close ties between these blocks.
To Next Page
Loading...
