590 Series DC Digital Drive Installing the Drive
3-35
Wire-Ended Encoder Option Board
ENCODER
The board accepts connection from a wire-ended encoder.
If fitted, refer to the Encoder Technical Manual for further information.
ENCODER OPTION
BOARD
Board
Control
Wire-ended Encoder
Tacho Calibration Option Board
ANALOG TACH
The board accepts connection from an analog tachogenerator.
If fitted, refer to Chapter 4: "Operating the Drive" - Speed Feedback Option Boards.
TACHO CALIBRATION
OPTION BOARD
Board
Control
Analog Tachogenerator
To Next Page
Loading...
