Perfecta 115 TS - Main Clamping Setting Instructions; Hydraulic Clamping System Maintenance

Service Manual 8 Hydraulic Clamping System
8.5 Hydraulic clamping system maintenance
1/09 PERFECTA 115 / 132 / 168 / 225 – TS 54
PERFECTA Schneidemaschinenwerk GmbH  D-02625 Bautzen  Schäfferstr. 44  Tel.: +49-3591-556-131 to -133  Fax: +49 3591-556-139
8.4.4 Main clamping setting instructions
In the "Clamping" section of the "Cutting Primer" you can obtain from PERFECTA,
you will find a few fundamentals on how to choose the proper clamping pressure.
Material-related figures based on experience can be found in the tables of the "Cutting
Primer" (Figures. 6 to 10).
They represent reference values for about two thirds of the maximum feed height and
cutting width. The Operating Manual contains diagrams for the individual machine
sizes where you can see clamping pressure curves vs. scaling. The "low", "medium"
and "high" ranges assigned to the various materials listed in the tables you find in the
"Cutting Primer" are explained and their assignment to the clamping force scaling
indicated.
8.5 Hydraulic clamping system maintenance
Please refer to "Hydraulic Oil Change", "Checking the Filter" and "Lubricants" in the
Operating Manual.