Service Manual 11 Electrical Equipment
11.5 Software
1/09 PERFECTA 115 / 132 / 168 / 225 – TS 78
PERFECTA Schneidemaschinenwerk GmbH D-02625 Bautzen Schäfferstr. 44 Tel.: +49-3591-556-131 to -133 Fax: +49 3591-556-139
11.5.2 Settings/operating data/"Settings" menu
From the "Settings" menu, you can set the values and functions for programming and
select backgauge feed data. Also, you can change the settings for the clamp stroke
limitation, the knife thickness correction, the push-out position, the clamping time ex-
tension, the "Clamping Only" period, the air-bed when programming backgauge target
positions as well as the active language. Moreover, you can activate the "Factory
Calibration", "Calibration" and "Set Measuring System" functions.
In addition, this menu includes the speed settings (v
max
, start and stop ramps) for target
position runs initiated through the keyboard or by the program.
Last but not least, the daily cut counts, lubrication cycle counts and the number of
knife changes are indicated. Please refer to para. 11.5.4.
To Next Page
Loading...