Helmet bay
•
Remove the side panels
•
Remove the licence plate holder tail.
•
Remove the saddle opening control
primary transmission.
•
Remove the internal light.
•
Remove the saddle light button con-
nections.
•
Remove the current socket connec-
tion.
•
Remove the start-up remote control
switch mounting screw.
•
Disconnect the two connectors (alter-
nated and direct three-phase) of the
voltage regulator, remove the chassis /
system strap and the cable stop on the
three-phase.
Through the six retainers, remove the helmet com-
partment with voltage regulator.
spoiler
•
Slide off the front fork together with the
wheel and the mudguard.
•
Remove the retainers between the
footrests indicated in the figure.
Beverly 500 i.e. Chassis
CHAS - 323
To Next Page
Loading...
