PIAGGIO Beverly 500 i.e. - Rear Central Cover

•
Remove the rear retainer.
•
Move the tank backwards and pull out
the front side downwards, then release
the rear side sideways.
For reassembly, perform the operations in the reverse order, paying attention to the following tightening
torques.
Locking torques (N*m)
Chassis cross-member lower screws 16 - 25 Chassis front cross member upper screws 6 to 10.5
Nm
Rear central cover
- Remove the saddle.
- Remove the 2 mounting screws shown in the fig-
ure.
Chassis Beverly 500 i.e.
CHAS - 326