PIAGGIO Beverly 500 i.e. - Removing the Rear Wheel

ALWAYS USE A NEW BEARING AND A NEW SEAT.
Specific tooling
001330Y Tool for fitting steering seats
Reassembly of tapered bearing in steering
tube
- Insert the a new plate and a new dust guard in
the steering tube
- Insert the a new tapered bearing in the steering
tube
- Using the special tool and a mallet to move the
dust guard and the bearing in abutment.
Specific tooling
006029Y Punch for fitting fifth steering bearing
on steering tube
Rear
Removing the rear wheel
- Remove the muffler support arm
- Remove the spacer on the gear shaft.
Suspensions Beverly 500 i.e.
SUSP - 272