Saddle opening ECU remote control.
Resetting of the remote control
Electronic control unit ECU
In order to access the immobilizer control unit, re-
move the upper shield back plate.
In order to access the connector, remove the wind-
shield with the respective support and the metal
plate holding the control unit ECU, decoder and
saddle opener remote control.
N.B.
AFTER INSERTING THE INTERFACE CABLE OR THE
ELECTRONIC CONTROL UNIT, RETIGHTEN THE SCREW
AND THE GROUND CABLE.
Immobiliser decoder
In order to access the immobilizer decoder, re-
move the upper shield back plate.
Electrical system Beverly 500 i.e.
ELE SYS - 36
To Next Page
Loading...
