PIAGGIO Beverly 500 i.e. - Page 96

- Tighten the bushing of the flywheel lock tool on
the removing tool threading.
- Insert the special tool as shown in the figure,
making sure that the pins are perfectly inserted in-
to the previously aligned holes and that it is per-
fectly abutted and almost flush with the flywheel.
Specific tooling
020472Y Flywheel lock wrench
- Loosen the magneto flywheel fastening nut.
- Remove the special tool and the fastening nut.
- Remove the washer.
Engine Beverly 500 i.e.
ENG - 96