Planet IGS-10020 Series - Page 27

User’s Manual
27
IGS-10080MFT
Model Name
IGS-10080MFT
Hardware Specifications
Copper Ports
2 10/ 100/1000BASE-T RJ45 Auto-MDI/MDI-X ports
SFP/mini-GBIC Slots
8 1000BASE-SX/LX/BX SFP interfaces (Port-1 to Port-8)
Compatible with 100BASE-FX SFP
Console
1 x RJ45 serial port (115200, 8, N, 1)
Switch Architecture
Store-and-Forward
Switch Fabric
20Gbps/non-blocking
Throughput (packet per second)
14.8Mpps@64Bytes
Address Table
8K entries, automatic source address learning and ageing
Shared Data Buffer
4Mbits
Flow Control
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
Jumbo Frame
9Kbytes
Reset Button
< 5 sec: System reboot
> 5 sec: Factory Default
ESD Protection
6KV DC
Enclosure
IP30 aluminum case
Installation
DIN-rail kit and wall-mount kit
Connector
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1; Pin 3/4 for fault alarm; Pin 5/6 for Power 2
Alarm
One relay output for power failure. Alarm Relay current carry ability: 1A @ 24V AC
LED Indicator
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Green)
Ring (Green)
R.O. (Green)
Per 10/100/1000T RJ45 Port:
1000 (Green)
LNK/ACT (Orange)
Per SFP Interface:
1000 (Green)
LNK/ACT (Orange)
Dimensions (W x D x H)
72 x 107 x 152mm
Weight
1036g
Power Requirements
DC 12 to 48V, AC 24V power adapter
Power Consumption
13.92 watts/47.76BTU (full loading)
Layer 2 Functions
Basic Management Interfaces
Web browser; Remote Telnet; SNMPv1, v2c; local console
Secure Management Interface
SSH, SSL, SNMPv3
Port Configuration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow Control disable/enable
Port Status
Display each port’s speed duplex mode, link status, flow control status, auto