Planet IGS-10020 Series - ACL Ports Configuration

User’s Manual
247
4.10.4 ACL Ports Configuration
Configure the ACL parameters (ACE) of each switch port. These parameters will affect frames received on a port unless the
frame matches a specific ACE. The ACL Ports Configuration screen in Figure 4-10-4 appears.
Figure 4-10-4: ACL Ports Configuration page Screenshot
The page includes the following fields:
Object Description
• Port
The logical port for the settings contained in the same row.
• Policy ID
Select the policy to apply to this port. The allowed values are 0 through 255.
The default value is 0.
• Action
Select whether forwarding is permitted ("Permit") or denied ("Deny").
The default value is "Permit".
• Rate Limiter ID
Select which rate limiter to apply on this port. The allowed values are Disabled or
the values 1 through 16.
The default value is "Disabled".
• EVC Policer
Select whether EVC policer is enabled or disabled. The default value is
"Disabled". Note that ACL rate limiter and EVC policer can not both be enabled.
• EVC Policer ID
Select which EVC policer ID to apply on this port. The allowed values are
Disabled
or the values
1
through
256
.
• Port Redirect
Select which port frames are redirected on. The allowed values are Disabled or a
specific port number and it can't be set when action is permitted. The default
value is "Disabled".
• Mirror
Specify the mirror operation of this port. The allowed values are:
■ Enabled: Frames received on the port are mirrored.
■ Disabled: Frames received on the port are not mirrored.
The default value is "Disabled".