Polaris 600 RUSH 2010 User Manual

3.40
Engine/Cooling/Exhaust
23. Reinstall the driven clutch assembly. Torque fastener
to specification.
24. Reinstall the drive belt.
25. Reinstall the airbox assembly. See “Air Box Servicing”
on page 2.24.
26. Reinstall the clutch cover/
oil tank assembly. See “Oil
Tank/Clutch Cover Service” on page 2.14.
27. Fill the coolant surge tank w
ith 60/40 Polaris engine
coolant. Follow the Cooling System Fill/Bleed
Procedure outlined in Chapter Two. See “Cooling
System Bleeding” on page 2.10.
28. Reinstall the hood assembly. See “Door/Hood
Removal and Installation” on page 2.25.
29. Reinstall the left and right door panels.
30. If the engine was rebuilt, follow the engine break-in
p
rocedure. See “Engine Break-In Procedure” on
page 2.6.
= T
Driven Clutch Bolt Torque: 18 ft-lbs (25 Nm)

Polaris 600 RUSH 2010 Specifications

General

Horsepower	120 HP
Engine Displacement	599 cc
Cylinders	2
Cooling	Liquid
Bore x Stroke	77.25 mm x 64 mm
Fuel System	Cleanfire Injection
Ignition	Digital CDI
Front Suspension	PRO-RIDE
Rear Suspension	PRO-RIDE
Track Width	15 in
Track Lug Height	1.25 in
Front Travel	9 in
Ski Stance	42.5 in
Brake	Hydraulic Disc
Width	48 in
Starter	Electric
Drive Clutch	P-85
Track Length	121 in
Rear Travel	14 in
Ski Type	Gripper
Driven Clutch	TEAM