Polyend Tracker - Step FX Descriptions

267
Polyend Tracker Manual
266
Polyend Tracker Manual
Performance Mode
12
Performance Mode
12
NOTESNOTES
12.6 Perform Effects List
Tracker has 21 performance effects that can be selected and loaded into
each of the 12 effect slots. The same effect can be applied to multiple slots.
While these are called effects, they in fact control parameters that apply
variations to the parameter values.
12.7 Remixing
Tracker can remix tracks on the y. There are two techniques worth noting
when applying track mixing. Firstly the ‘Pattern Play Mode’ effect has 20
algorithms C1-C20 that allow pattern mixing based on predened shufing
of existing patterns. This is called ‘Custom Play Mode’. Secondly tracks can
manually be remixed live when playing a song. Both techniques operate in
performance mode.
Custom Play Mode
▌ USING A CUSTOM PATTERN PLAY EFFECT
1. Press [Perform] to select the Performance Mode page.
2. Press [Rec] to select record mode. Values and bounding box are red.
3. Navigate between effect slots, Press [Left] or [Right].
4. To load the effect for the selected slot, Press [Up] or [Down]. Select the
‘Pattern Play Mode’ effect.
5. Hold [PAD] + Turn (Jog) to change the value of the specic effect row.
Fwd-Forward, Rev- Reverse and Rnd - Random options as well as ‘C’
options. Set the following example as a starting point. Any C1-C20
value can be selected:-
• Pad row 2 is the 2
nd
row of effect values Set to C18.
• Pad row 3, is 3
rd
row of effect parameters. Set to C19.
• Pad row 4, is the 4
th
row of effect parameters. Set to C20.
6. It is possible to set up, other ‘Pattern Play Mode’ effects into other slots
to cover more of the other C1-C17 custom presets.
7. Press [Rec] to turn record mode off.
8. Trigger the pads to activate the alternate mixes based on the predened
‘C’ Setting triggered. Also it is possible to use slot 1 as a dynamic and
temporary change by holding [PAD] Row 1 and Turning (Jog). This will
clear when released.
Effect # Name Range / Comments
1 Volume
-100 to +100.
Volume level adjustment
2 Panning
-100 to +100
Stereo Position
3 Tune
-48 to +48
Semitones. Also applies to MIDI.
4 Low-Pass Cutoff
-100 to +100.
Filter frequency adjustment
5 High-Pass Cutoff
-100 to +100.
Filter frequency adjustment
6 Band-Pass Cutoff
-100 to +100.
Filter frequency adjustment
7 Reverb Send
-100 to +100.
FX Send level
8 Delay Send
-100 to +100.
FX Send level
9 Sample Position
-100 to +100.
Audio sample start position
10 Sample End
-100 to +100.
Audio sample end position
11 Sample Playback
<<< >>>
Backward, Forward direction.
12 Volume LFO Speed
-28 to +28.
LFO Speed
13 Panning LFO Speed
-28 to +28.
LFO Speed
14 Finetune LFO Speed
-28 to +28.
LFO Speed
15 Filter LFO Speed
-28 to +28.
LFO Speed
16 Grain/WT LFO Speed
-28 to +28.
LFO Speed
17 Step Repeater
Off, 16, 12, 8, 6, 4, 3, 2, 1, 1/2, 1/3, 1/4, 1/6,
1/8, 1/12, 1/16.
18 Pattern Play Mode
Fwd, Back, Rnd, C1-C20
Fixed or Predened algorithm ‘C’ play modes
19 Pattern Length
1-128
Total length (all tracks - selected or not)
20 Bit Depth
-12 to +12
Bit depth adjustment
21 Overdrive
-100 to +100
Overdrive adjustment