Polyend Tracker - 4.4 Copying and Pasting a Pattern; 4.5 Inverting a Selection of Steps.

55
Polyend Tracker Manual
54
Polyend Tracker Manual
NOTES
Pattern Format
4
Pattern Format
4
4.4 Copying and Pasting a Pattern.
Patterns can be copied and pasted between different pattern slots. This will
copy the entire pattern and its steps as well as the length conguration.
▌ COPYING AND PASTING A PATTERN
1. Press [Pattern] to select the pattern mode page.
2. The options on pages 1 & 2 are required during this process. Press
[More] to toggle between the two pages of pattern options.
3. Press [Rec] to select recording mode and allow editing. Screen buttons
will be unavailable, shown dim, otherwise.
4. On pattern page 1, select the pattern to copy, Hold [Pattern] 1
st
Screen
button + Turn (Jog). Example, select Pattern 1.
5. On pattern page 2, Press [Copy] Screen Button. The pattern is copied
to the clipboard.
6. On pattern page 1, select the pattern to paste into, Hold [Pattern] 1
st
Screen button, + Turn (Jog). Example, select Pattern 2.
7. On pattern page 2, Press [Paste] Screen Button. The pattern is pasted
into the current pattern and will overwrite any existing data. It is possible
to continue to paste the pattern to other pattern slots.
8. The [Undo] or [Redo] screen buttons can be used if required to restore
a previous pattern state.
4.5 Inverting a Selection of Steps.
Patterns are created top to bottom and steps assigned in the step rows.
Steps once selected in a pattern can be inverted. This will reverse the order
in which the steps play. For example the rst step in the selection will play
last and vice versa.
▌ INVERTING A STEP RANGE IN A PATTERN
1. Press [Pattern] to select the pattern mode page.
2. Ensure options page 2 is displayed. Press [More] to toggle between the
two pages of pattern options.
3. Press [Rec] to select recording mode and allow editing. Screen buttons
will be unavailable, shown dim, otherwise.
4. Navigate to the rst step. Press [Shift] + [Up] or [Down] to select the
sequence of steps and / or Press [Shift] + [Left] + [Right] to select steps
across tracks.
5. Press [Invert] Screen Button to reverse the order of the range of steps
selected. This reverses the vertical order of the steps. The steps remain
in their respective tracks.
6. The [Undo] or [Redo] screen buttons can be used if required to restore
a previous state.
Original Range
Selected Range 2 - 4 Bounded in Red
Inverted Range
Inverted Range 2-4 Bounded in red
Track 1 Track 1Track 2 Track 2
Step 1 Step 1
Step 2 Step 2
Step 3 Step 3
Step 4 Step 4
C6 40
----
P 25 C6 40
----
P 25
C6 40
----
P 25
C6 40
----
P 25
E5 40
----
P 25
C6 40
----
P 25 C6 40
----
P 25
E5 40
----
P 25
NOTES