Polyend Tracker - Architecture

37
Polyend Tracker Manual
36
Polyend Tracker Manual
3.5 Metronome
Tracker has a metronome which operates when live recording (not normal
playback). This is congurable and selectable on/off within the ‘Cong’
menu under the ‘Metronome’ options.
Option Parameters Description
State
On, Off
Default Off
Toggles the metronome on or off.
Pre Roll
On, Off
Default Off
Sets a count in before the sequencer starts to
help timing of punch in recording.
Ideal for live recording.
Time signature num
1 - 12
Default 4
Number of beats in a measure / bar. Upper
number in the normal time signature value.
Example 4/4 set to 4 beats per measure.
Time signature denum
1 - 12
Default 4
Beat value, division of note. Lower number in
the normal time signature value. Example 4/4
has a quarter note per beat.
Volume
1 - 100
Default 50
Volume of the metronome’s ‘tick’ sound
Press [Left] or [Right] to navigate between the option windows
and use [Up] or [Down] to navigate to the desired option.
Metronome Settings.
▌ SETTING THE METRONOME
1. Press [Cong] to open the project conguration menu.
2. Ensure the left window is highlighted red i.e. in focus. Navigate windows
by pressing [Left] or [Right]. Menu windows will automatically be
selected when pressing the relevant screen keys below the window to
navigate [Up] or [Down].
3. Press [Up] [Down] or Turn (Jog) to highlight with the bounding box over
the ‘Metronome’ option. Alternatively press the relevant screen keys
below the window to navigate [Up] or [Down].
4. Press the relevant screen keys below the window to navigate [Up] or
[Down] under the central options to highlight with the bounding box over
the required Metronome option.
5. To change the selected parameter / setting, Press [Change], 6
th
Screen
button. The parameter pop-up window listing the available options will
appear.
6. Turn (Jog) or Press [Up] / [Down] or [Up] / [Down] Screen Buttons to
highlight the desired option.
7. Press [Apply], 6
th
Screen button to conrm selection or [Cancel], 3
rd
Screen button to exit without changing.
8. The metronome will operate at the chosen time signature and volume
when live recording is activated using [Rec] + [Play]. The Pre roll will
provide a count in of 4 and show the ‘Recording in 4. 3. 2. 1.’ message
before starting to record.
NOTESNOTES
Projects
3
Projects
3
Change
Project Settings State Off
General Pre Roll Off
MIDI Time signature num 4
Metronome Time signature denum 4
Firmware Volume 50
Manual
Credits
Cong 0m:00s P1.008
Config