7088-8000
-151
Fluid Viscosity
Fluid viscosity is configurable only if
OTHER
was selected as the fluid type. If
OTHER
was not selected, the fluid viscosity is available for viewing only.
To set the fluid viscosity:
1. From the
FLUID
options group, click on the
VISCOSITY
text box.
2. Enter the kinematic viscosity of the fluid.
NOTE:
Refer to Appendices C and D for information on fluid viscosities.
F.4.4 TRANSDUCER OPTION GROUP
The
TRANSDUCER
option group is accessed by clicking on
TRANSDUCER
in the
Options Column. This group contains the options related to the transducer, including
selection of the transducer type, transducer mounting method, and spacing requirements.
Transducer Type
The flowmeter must be configured for the correct transducer arrangement – either with or
without the optional high-temperature blocks (Section 4.5).
To select the transducer type:
1. From the
TRANSDUCER
options group, click on the down arrow to the right of the
TYPE
text box.
The following selections are displayed:
!
STANDARD
!
HI TEMPERATURE
2. Click on the desired transducer type.
NOTE: STANDARD
should be selected unless the optional high-temperature blocks
are used.
Transducer Mounting
The transducer can be mounted with the V, W or Z method (Section 4.4).
To select the transducer mounting method:
From the
TRANSDUCER
options group, click on the down arrow to the right of the
MOUNT
text box.
The following selections are displayed:
!
V
!
W
!
Z
To Next Page
Loading...
Need help?
General