Appendix C
A-97
A.5.1 TRANSFERRING A DATA LOG FILE
To transfer a data log file:
1. From the Data Logger screen, use the arrow keys to select a data log file.
2. Select
TRANSFER FILE
.
The following message is displayed:
ENTER DESTINATION FILE NAME:
3. Enter the new file name for the transferred file and press
ENTER
.
NOTE:
The following rules apply to the new name selected for the data log file:
!
The new file name for the transferred file may have up to eight valid
characters and an extension of up to three valid characters.
!
If running PolyLink from a PC and the destination for the file is different
than the current directory used by PolyLink, a full path file name should be
entered.
!
If running PolyLink from a DDF3088, the destination for the file is
predetermined and is not selectable. In addition, to be able to view the
transferred file on the DDF3088 in strip chart format, the new file name
must include a .DFM extension.
After the file name is entered, the following is displayed:
DISPLAY XXXXXXXX’S INFORMATION:
DATE: 00-00-00
TIME: 00:00:00
UNITS: XXX
CONVF 0.00000000e+00
INTERVAL: 0.000
SIZE: 0
A rotating cursor is displayed indicating that the transfer is in progress. After the
transfer is finished, the following is displayed:
TRANSFER COMPLETE
A.5.2 VIEWING A DATA LOG FILE IN STRIP CHART FORMAT
If PolyLink is run from a DDF3088 (Section A.2.2), any transferred data log files which
contain a .DFM extension can be viewed as strip charts in the DDF3088 flow program.
To view a transferred file in strip chart format on a DDF3088:
1. Press the
ESC
key on the DDF3088 twice to exit PolyLink.
2. Enter the Battery Setup parameters for the DDF3088 flow program, pressing
ENTER
after each one.
To Next Page
Loading...
Need help?
General