7088-8000
-23
CONFIGURING AND OPERATING THE
FLOWMETER
This chapter provides step by step procedures for configuring and operating the instrument
with the keypad and display. The configuration settings are stored in non-volatile memory
to protect them in the event of a power failure.
After the flowmeter has been configured, the transducers are spaced and installed on the
pipe (Chapter 4). If accuracy at low flows is important, the flowmeter should also be
calibrated (Chapter 5).
NOTE:
The instrument can also be configured through the RS232 interface with an IBM-
compatible PC using the PolyLink or
TimeGATE
™
utilities (Appendices A
and F).
To Next Page
Loading...