POLYSONICS DCT-7088 - Page 26

7088-8000
-26
Table 3-1 provides a list of the menu addresses:
Table 3-1
Menu Addresses
PRIMARY DISPLAYS:
Flow/Net Totalizer (Menu 00)
Flow/Velocity (Menu 01)
Flow/Positive Totalizer (Menu 02)
Flow/Negative Totalizer (Menu 03)
Signal Strength/Low Signal Cutoff (Menu 04)
PIPE:
Pipe OD (Menu 10)
Pipe Wall Thickness (Menu 11)
Pipe ID (Menu 12)
Pipe Material (Menu 13)
Pipe Sound Speed (Menu 14)
Pipe Inside Roughness (Menu 15)
LINER:
Liner Material (Menu 16)
Liner Thickness (Menu 17)
Liner Sound Speed (Menu 18)
Liner Inside Roughness (Menu 19)
FLUID:
Fluid Type (Menu 20)
Fluid Sound Speed (Menu 21)
Fluid Viscosity (Menu 22)
TRANSDUCER:
Transducer Type (Menu 23)
Transducer Mounting (Menu 24)
Transducer Spacing (Menu 25)
FLOW:
Flow Units (Menu 30)
Max Flow Range (Menu 31)
Min Flow Range (Menu 32)
Damping (Menu 33)
Low Flow Cutoff (Menu 34)
Low Signal Cutoff (Menu 35)
TOTALIZER:
Totalizer Units (Menu 36)
Totalizer Multiplier (Menu 37)
Net Totalizer (Menu 38)
Positive Totalizer (Menu 39)
Negative Totalizer (Menu 40)
Totalizer Reset (Menu 41)
OPTIONS:
Measurement Units (Menu 42)
Site Parameters (Menu 43)
RS232 Configuration (Menu 46)
Change System Password (Menu 47)
Change Scale Factor Password (Menu 48)
Unit ID (Menu 49)
CALIBRATION (Menu 50):
Zero Set (Menu 51)
Scale Factor (Menu 52)
Sound Speed Compensation (Menu 53)
Date and Time (Menu 54)
CURRENT LOOP (Menu 56):
Current Loop Span (Menu 57)
Current Loop Calibration (Menu 58)
Current Loop Test (Menu 59)
ALARMS (Menu 70):
Program Alarms (Menu 71)
View Alarms (Menu 72)
DATA LOG
Data Log Setup (Menu 80)
Data Log Interval (Menu 81)
DIAGNOSTICS:
Signal Strength/Margin (Menu 90)
Delta Time/Fluid Sound Speed (Menu 91)
Reynolds #/Profile Factor (Menu 92)
Current Loop Output (Menu 93)
Software/Firmware Rev. Level (Menu 94)
PRINT:
Print Log Setup (Menu 96)
Prints Settings (Menu 97)
Prints Diagnostics (Menu 98)
Prints Current Screen (Menu 99)