7088-8000
-34
Liner Material (Menu 16)
This menu is used to select one of the following liner
materials:
!
NONE
(no liner)
!
TAR EPOXY
!
RUBBER
!
MORTAR
!
POLYPROPYLENE
!
POLYSTYROL
!
POLYSTYRENE
!
POLYESTER
!
POLYETHYLENE
!
EBONITE
!
TEFLON
!
OTHER
NOTE:
The selection
OTHER
denotes a material not
listed. If
OTHER
is selected, the liner sound
speed (Menu 18) and liner inside roughness
(Menu 19) must be entered.
Liner Thickness (Menu 17)
This menu is used to enter the thickness of the liner.
Liner Sound Speed (Menu 18)
This menu is configurable only if
OTHER
was selected
for the liner material in Menu 16. The liner sound
speed of the
OTHER
material should be entered in this
menu. If
OTHER
was not selected, this menu is
available only by the direct access method and not by
scrolling. In this case, this menu functions as a view-
only display to indicate the liner sound speed from the
flowmeter’s data base.
Liner Material
*POLYETHYLENE
Liner Thickness
0.00 Inches
Liner Sound Speed
8203.00 FPS
To Next Page
Loading...
Need help?
General