POLYSONICS DCT-7088 - Page 4

7088-8000
-4
CHAPTER 3:
CONFIGURING AND OPERATING THE FLOWMETER 3-1
3.1 KEYPAD AND DISPLAY...............................................................................................3-2
3.1.1 KEYPAD AND DISPLAY COMPONENTS............................................................................................3-2
3.1.2 DISPLAY CONTRAST AND BACKLIGHT...........................................................................................3-3
3.2 DIRECT MENU ACCESS...............................................................................................3-3
3.3 ACCESSING THE MENUS BY SCROLLING ............................................................ 3-5
3.3.1 SCROLLING THROUGH THE MAIN MENU AND SUB-MENUS......................................................3-5
3.3.2 SCROLLING THROUGH PRIMARY DISPLAYS, SETUP MENUS,
AND DIAGNOSTIC MENUS ..................................................................................................................3-6
3.4 ENTERING DATA IN THE SETUP MENUS .............................................................. 3-6
3.5 QUICK SETUP.................................................................................................................3-7
3.6 PRIMARY DISPLAYS, SETUP MENUS, AND DIAGNOSTIC MENUS................. 3-8
3.6.1 PRIMARY DISPLAYS.............................................................................................................................3-8
3.6.2 PIPE SETUP MENUS...............................................................................................................................3-9
3.6.3 LINER SETUP MENUS .........................................................................................................................3-11
3.6.4 FLUID SETUP MENUS .........................................................................................................................3-13
3.6.5 TRANSDUCER SETUP MENUS...........................................................................................................3-14
3.6.6 FLOW SETUP MENUS..........................................................................................................................3-15
3.6.7 TOTALIZER SETUP MENUS ...............................................................................................................3-18
3.6.8 OPTIONS SETUP MENUS ....................................................................................................................3-21
3.6.9 CALIBRATION SETUP MENUS..........................................................................................................3-25
3.6.10 CURRENT LOOP SETUP MENUS .....................................................................................................3-27
3.6.11 ALARMS SETUP MENUS ..................................................................................................................3-28
3.6.12 DATA LOG SETUP MENUS...............................................................................................................3-30
3.6.13 DIAGNOSTICS DISPLAY MENUS....................................................................................................3-33
3.6.14 PRINT SETUP AND PRINT COMMANDS........................................................................................3-34
3.7 MASTER ERASE FUNCTION AND
EMERGENCY OVERRIDE PASSWORDS ............................................................... 3-37
3.7.1 EMERGENCY OVERRIDE PASSWORDS...........................................................................................3-37
3.7.2 MASTER ERASE FUNCTION ..............................................................................................................3-37
CHAPTER 4:
INSTALLING THE TRANSDUCERS.................................... 4-1
4.1 MEASUREMENT SITE SELECTION.......................................................................... 4-1
4.2 SPACING AND MOUNTING THE TRANSDUCERS................................................4-3
4.2.1 USING THE SLIDE TRACK....................................................................................................................4-4
4.3 ALIGNING THE TRANSDUCERS............................................................................... 4-5