7088-8000
-48
Zero Set (Menu 51)
This menu is used to select one of the following
zeroing (calibration) methods:
!
NO FLOW
(zero set calibration)
!
MANUAL
(manual zero set calibration)
Refer to Section 5.1 for detailed information on the
zero set calibration methods.
Scale Factor (Menu 52)
This menu provides a means for the operator to adjust
the instrument-displayed flow. The flow measured by
the instrument is multiplied by this value. Refer to
Section 5.2 for detailed information on the scale factor.
Sound Speed Compensation (Menu 53)
This menu is used to turn on or off the flowmeter's
sound speed compensation. Temperature variations in
the fluid and other factors may cause variations in the
fluid’s sound speed. Typically, the flowmeter can
determine the sound speed more accurately when
sound speed compensation is enabled.
Date and Time (Menu 54)
This menu is used to set the date and time in the
internal clock of the flowmeter. The time is expressed
in military time (24 hour format) and the date is in the
month-day-year format.
To set the date and time:
1. Access Menu 54.
2. Press
ENTER
.
Prompts are displayed one screen at a time
requesting month, day, and year entries for the date
and hour, minute, and second entries for the time:
3. Enter the requested date and time parameters for
each screen, pressing
ENTER
after each entry.
Set Zero
!
!!
!
No Flow
!
!!
!
Manual
Scale Factor
0.9850
Sound Speed Comp.
*Enabled Disabled
Date and Time
12-01-96 14:07:17
Date and Time?
Month? 12
To Next Page
Loading...
Need help?
General