7088-8000
-57
The flow data is printed in minimum, maximum, and
average flow rates. The minimum and maximum rates
are automatically reset at the end of each print period.
The average flow rate is the average over the print
interval.
To configure the printer:
1. Access Menu 96:
2. Select one of the following options:
!
NONE
(disables the printer)
!
FLOW
(configures the printer to print out flow
data at the preset log interval)
!
ALARM
(configures the printer to print out flow
data when an alarm is activated)
!
BOTH
(configures the printer to print out flow
data at the preset log interval and when an
alarm is activated)
3. If
FLOW
or
BOTH
was selected, press the
DOWN
ARROW
key to set the print interval.
The following is displayed:
4. Enter the print interval in whole seconds and press
ENTER
.
NOTE 1:
If the log interval is too short to allow
the selected data to be printed, erratic
operation may result.
NOTE 2:
If the print interval is interrupted by a
power loss, the printer resumes printing
at the prescribed interval after power is
restored.
Prints Settings (Menu 97)
All parameters associated with the pipe, liner, fluid,
transducer, and flow menus (Menus 10 through 35) can
be printed out by pressing
MENU
and 97.
Print Select
*None Flow Alarm
Print Interval
30 sec.
To Next Page
Loading...
Need help?
General