Appendix C
A-88
4. Create a directory called DDF (if the DDF directory does not already exist).
NOTE:
To create the DDF directory, enter the following commands at the C: prompt
one at a time, pressing
ENTER
after each one:
C:
CD\
MD DDF
5. Copy PLXXXZ.EXE to the DDF directory (substituting the current version number for
the Xs):
If the file was received on diskette, it should be copied from the diskette drive. If the
file was downloaded from the BBS, it should be copied from the directory where the
modem software placed it.
NOTE:
To copy the file PLXXXZ.EXE to the DDF directory:
!
Go to the directory where PLXXXZ.EXE is located. (If PLXXXZ.EXE is
located on diskette, insert the diskette into the diskette drive. Enter the drive
letter followed by a colon and press
ENTER
. For example, if the diskette
drive is drive A, enter A: and press
ENTER
.)
!
Enter the following (substituting the correct version number for the Xs) and
press ENTER:
COPY PLXXXZ.EXE C:\DDF
6. Go to the DDF directory.
NOTE:
To go to the DDF directory, enter the following commands one at a time,
pressing
ENTER
after each one:
C:
CD\
CD DDF
7. Unzip PLXXXZ.EXE by typing the file name PLXXXZ (without the extension) and
pressing
ENTER
. (Substitute the correct version number for the Xs):
NOTE:
A message may be displayed while PLXXXZ.EXE is unzipping indicating
that a file with the same name already exists. Enter Y (for YES) for
permission to overwrite the file and press
ENTER.
PLXXXZ.EXE produces the unzipped file PL.EXE.
8. Enter PL and press
ENTER
.
The PolyLink welcome screen is displayed.
9. Press
ENTER
again.
To Next Page
Loading...
Need help?
General