6. Verify the Step-up belt tension, see "Belt Tension and Alignment Verification" on
page50.
a. If the Step-up belt tension is out of specification limits. then re-tension both the
Drive belt and Step-up belt to specification, see "Belt Tension Adjustment and
Alignment Procedure" on page53.
7. Replace all removed covers, see "Covers and Panels Replacement" on page75.
8. Do the Operation Verification tests (see "Operation Verification" on page19) and
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 143
6 Available Replacement Procedures
Idler Pulley Replacement
To Next Page
Loading...
Need help?
General
